How To Use The Bissell Pet Pro Revolution: Easy Steps

Fill the clean tank to the line with hot tap water and Bissell formula, choose the right mode, and make steady wet and dry passes.

You came here to master how to use the bissell pet pro revolution, and you will. I clean homes with pets for a living, and I have used this machine for years. In this guide, I break down how to use the bissell pet pro revolution step by step. You will learn setup, modes, stain tactics, drying, and care. Follow along, and your carpets will look and smell new again.

What You Need Before You Start

Preparation saves time and avoids mistakes. Gather a few items first.

Bissell ProHeat 2X Revolution Pet Pro and power cord. Check the brush for hair.
Bissell carpet formula. Pet Pro Oxy or Antibacterial for tough pet messes.
Hot tap water. Not boiling. The machine keeps it warm as you clean.
A vacuum. Dry vacuum your carpets first.
Towels, a bucket, and gloves for severe spots.
Pet tools and attachments if you plan to do stairs or upholstery.

Do a quick test in a hidden spot. Press the tool on the carpet for a few seconds. Check colorfastness. This is rare to fail, but it is smart.

Quick Start: Step-by-Step on how to use the bissell pet pro revolution

Follow these simple steps the first time. It only takes a few minutes to set up.

Vacuum your floors
Remove hair, litter, grit, and food. This boosts suction and cuts streaks.
Fill the clean water tank
Use hot tap water up to the line. Add formula to the marked fill line. Do not guess the ratio. The tank has easy marks.
Seat the tank and plug in
Set the clean tank until it clicks. Plug the unit into a grounded outlet.
Pick a clean mode
Choose Express Clean for light soil and faster dry. Choose Deep Clean or Max Clean for pet stains and high traffic.
Pre-treat spots (optional but best for pets)
Use CleanShot if your model has it, or spray Bissell pre-treater. Let it sit 3–5 minutes.
Start cleaning with smooth passes
Squeeze the trigger and push forward. This wets the carpet and loosens soil.
Keep holding the trigger and pull back over the same path. This extracts soil and water.
Let go of the trigger. Make one or two slow dry passes over the same path. This speeds drying.
Overlap each path by an inch
It prevents streaks. Move slow and steady. Think of mowing a lawn.
Empty the dirty tank when it hits the line
Rinse the tank and float. Refill the clean tank as needed. Fresh water cleans better.
Finish with extra dry passes
Do a final pass without the trigger over the whole area. It reduces dry time a lot.
Ventilate
Turn on fans. Open windows if the air is dry outside. A box fan works great.

This is how to use the bissell pet pro revolution for a whole room. The same flow works in halls, stairs, and rugs.

Deep Clean Modes and Settings Explained

Knowing each mode saves time and water. It also protects your floors.

Express Clean
Best for maintenance. Light soil. Faster dry, often around one hour in ideal airflow. Use a slow forward and back pass, then one dry pass.
Deep Clean or Max Clean
Best for heavy pet areas and old stains. Expect more water use and longer dry. Use two dry passes for each wet pass.
CleanShot pretreater (on many Pet Pro models)
Shoots solution right at the stain. Great for urine edges and muddy paw prints. Use short bursts.
HeatWave Technology
Keeps your water warm. You still need hot tap water to start strong.
Edge cleaning
Run the machine along baseboards to lift hair lines. A slow pass works best.
Upholstery mode
Switch to the hose. Select the right tool. Many Pet Pro models include a 2-in-1 pet upholstery tool that handles dry hair and wet mess.

Match mode to the job. For new spills, Express Clean often wins. For old pet odor in high traffic, choose Deep or Max and go slow.

Tackling Pet Messes: Spots, Odors, and Upholstery

Pet mess needs a plan. Here is how I handle the common ones.

Fresh urine

Blot with a towel first. Do not rub.
Pre-treat the spot and edges. Wait 3–5 minutes.
Use Deep Clean. Wet pass once, then two slow dry passes.
Repeat if odor remains. Dry passes are key.

Old urine or unknown stains

Pre-treat and agitate with the brush tool.
Let dwell 5–10 minutes.
Deep Clean with slow passes.
Rinse with plain water to remove residue. Do extra dry passes.

Mud and paw prints

Let heavy mud dry. Vacuum first.
Express Clean for light soil. Deep Clean for caked dirt.
Use overlapping paths. Dry passes to finish.

Upholstery and stairs

Attach the hose. Pick the pet tool.
Mist the fabric with the trigger. Do short strokes.
Release the trigger. Extract with several dry strokes.
Do not over-wet cushions. Stand them up to dry.

Area rugs

Check the rug tag. Test colorfastness.
Clean top only. Avoid soaking fringe.
Place a fan on low and lift the rug edge for airflow.

This is the heart of how to use the bissell pet pro revolution for real pet life. Patience and dry passes beat odor every time.

Drying Faster and Preventing Overwetting

Dry time depends on soil, humidity, and airflow. You can speed it up a lot.

Use one wet pass, two dry passes on carpet. Three dry passes for thick pile.
Run a fan or dehumidifier. Close windows if it is humid outside.
Set the home HVAC fan to On for an hour.
Lift furniture on foil or plastic blocks until dry.
If you see foam, stop and rinse with plain water. Foam slows suction.

These steps prevent wicking. That is when stains creep back up as the carpet dries.

Maintenance After Every Use

Care after each job makes the next job easy. It also protects your machine.

Empty and rinse the dirty tank
Rinse the tank, lid, and red float. Wipe the seals. Let them air dry.
Clean the nozzle and brushes
Pop off the front nozzle. Rinse hair and grit. Check the brush roll area. Cut and pull pet hair. Rinse and snap back in place.
Wipe the clean tank
If you mixed extra formula, pour it out. Fill with a bit of warm water. Swish and empty. Store tanks dry.
Check filters and gaskets
Remove lint from screens. Inspect o-rings. A little care stops leaks.
Store the unit upright
Wrap the cord. Keep it in a dry place. Do not leave water in the unit.

Do this every time. Your suction will stay strong and your floors will thank you.

Troubleshooting and Pro Tips from Experience

Small issues are easy to fix at home.

Low suction

Check the dirty tank lid. It must seat tight.
Clean the nozzle of hair.
Make sure the float is not stuck up from foam.

No spray

Re-seat the clean tank.
Refill water and formula.
Prime by holding the trigger for 15–30 seconds.

Brush not spinning

Turn the unit off. Check for strings or hair.
Some models stop brushes when the handle is upright. Recline the handle.

Streaks or track marks

Slow down. Overlap each pass.
Rinse with plain water. Then do extra dry passes.

Odor returns next day

That means wicking. Re-treat the spot. Do slow dry-only passes.
Use a fan for two hours.

Pro tips I use on every job

Less is more. Do not soak. Let chemistry and time work.
Hot tap water cleans best. Never use boiling water.
For big rooms, split into halves. Empty and refill between halves.
Keep a small towel in your pocket. Wipe the nozzle face every few rows. It keeps lines sharp.

This is practical, field-tested advice on how to use the bissell pet pro revolution with pets in the home.

Safe Use, Formulas, and Warranty Notes

A few safety and care points matter.

Use only Bissell-approved carpet formulas. The manufacturer recommends them for foam control and pump care. Damage from other solutions may not be covered.
Do not use bleach, solvents, or boiling water. They can harm carpets and internal seals.
Always vacuum first. Dry soil is abrasive and clogs airflow.
Keep the machine moving. Do not hold the trigger in one spot.
Check your floor type. Use caution on natural fibers, sisal, and non-colorfast rugs.

These simple rules help your machine last. They also keep your carpet warranty safe.

Frequently Asked Questions of how to use the bissell pet pro revolution

What solution ratio should I use?

Use the fill lines on the clean tank for water and formula. The tank shows the right mix for small and large jobs, so you do not need to measure.

Can I use hot water from the kettle?

Use hot tap water only. Boiling water can warp parts and may damage fibers.

How long does the carpet take to dry?

With Express Clean and good airflow, many carpets dry in about an hour. Deep or Max Clean can take 4–6 hours, sometimes more in humid rooms.

Should I vacuum before cleaning?

Yes, always vacuum first. It lifts hair and grit so the machine can focus on deep soil.

Can I use it on area rugs?

Yes, if the rug is colorfast and water-safe. Avoid fringe, and dry with a fan.

How often should I deep clean with pets?

High-traffic homes with pets do well with monthly maintenance and quarterly deep cleans. Spot clean right away for best odor control.

How do I stop pet odor from coming back?

Pre-treat, clean slow, and do extra dry passes. Improve airflow after cleaning to prevent wicking and trapped moisture.

Conclusion

You now know how to use the bissell pet pro revolution like a pro. Fill with hot tap water and the right formula, choose the best mode, make slow overlapping passes, and finish with extra dry strokes. Pre-treat spots, ventilate well, and clean the machine after each job.

Put this plan to work on one room today. You will see brighter color and smell fresh air fast. Want more tips and real-world tricks? Subscribe, leave a comment with your toughest stain, and I will help you solve it.